Hello everyone...
I'm interested in building a P3A to power a pair of Whatmough floorstanding loudspeakers in my lounge room.
I've built a few amplifiers kits, most recently the 41hz AMP6 which is powering my computer speakers. This is the first time I've had to source my own components. Note: I'll be ordering Rod's PCB.
After doing some reading here there seems to be a whole range of different suggestions for output transistors and passive components.
I'd really appreciate a "Bill of materials" consisting of good quality but not exotic components that will result in a great sounding amp. I'd prefer to buy everything from a single source such as Digikey or RS electronics since shipping to Australia is very expensive.
I'm interested in building a P3A to power a pair of Whatmough floorstanding loudspeakers in my lounge room.
I've built a few amplifiers kits, most recently the 41hz AMP6 which is powering my computer speakers. This is the first time I've had to source my own components. Note: I'll be ordering Rod's PCB.
After doing some reading here there seems to be a whole range of different suggestions for output transistors and passive components.
I'd really appreciate a "Bill of materials" consisting of good quality but not exotic components that will result in a great sounding amp. I'd prefer to buy everything from a single source such as Digikey or RS electronics since shipping to Australia is very expensive.