Hi guys i have some real troubling problems with my sherwood amp, other than its 100 years old and cant afford a schematic .. i realy need 2 photos / resistor codes if someone could help me out that would be soo greatly appreciated.
i need a good quality photo of the protection board ( it has a 5112100 stamp on it its small & square, fits in your palm the other is onthe left side of the power supply (right near the relay) there is a couple of little green resistors i need to see the codes for they, same with the protect board i'll note their names
i would love to hear this amplifier, the only way that will happen is if i can repair it, i have no problem fixing things but the resistors are completely fried and i cant read their bands! please help!!
the codes are (POWER/AMP BOARD) R401R & R401L (Their located near the 2 10 ohm 2 watt resistors (grey colour risen off the board)
and R329R & R329L (PROTECT BOARD)
I have replaced the 2 left and right R330 resistors with 1 watt resistors, even if someone has a service manual i would realy love if i could have some help please please helpp!!
i need a good quality photo of the protection board ( it has a 5112100 stamp on it its small & square, fits in your palm the other is onthe left side of the power supply (right near the relay) there is a couple of little green resistors i need to see the codes for they, same with the protect board i'll note their names
i would love to hear this amplifier, the only way that will happen is if i can repair it, i have no problem fixing things but the resistors are completely fried and i cant read their bands! please help!!
the codes are (POWER/AMP BOARD) R401R & R401L (Their located near the 2 10 ohm 2 watt resistors (grey colour risen off the board)
and R329R & R329L (PROTECT BOARD)
I have replaced the 2 left and right R330 resistors with 1 watt resistors, even if someone has a service manual i would realy love if i could have some help please please helpp!!