Hello, I am in need of assistance. I am building a bit of a strange subwoofer using this woofer....
The Madisound Speaker Store
My enclosure is about .28 cubic feet. I have some bends to take inside the compartment and would love to use some sink drain pipe that works perfectly. Its 1 3/8" thick.
My amp is a class d 2.1 and I am unsure where the subwoofer cutoff is, so your judgement is fine on where to tune the box, perhaps around 70hz?
http://www.ebay.com/itm/TPA3116-2-1-...item565cfa1638
Its my understanding that its the volume of the port that is important, so if your calculator only has 1.5 inch ports, I can calculate it out from there.
ps. Is it really bad for the port interior opening to face the cone, even if its 5 inches away, or is that a urban legend?
Many thanks, those calculators confuse me~
Tor
The Madisound Speaker Store
My enclosure is about .28 cubic feet. I have some bends to take inside the compartment and would love to use some sink drain pipe that works perfectly. Its 1 3/8" thick.
My amp is a class d 2.1 and I am unsure where the subwoofer cutoff is, so your judgement is fine on where to tune the box, perhaps around 70hz?
http://www.ebay.com/itm/TPA3116-2-1-...item565cfa1638
Its my understanding that its the volume of the port that is important, so if your calculator only has 1.5 inch ports, I can calculate it out from there.
ps. Is it really bad for the port interior opening to face the cone, even if its 5 inches away, or is that a urban legend?
Many thanks, those calculators confuse me~
Tor