BRZ 1700.1d

hi all
This amp came in with one shorted output.I remove all the outputs from the board.
I have both - + reg and rail voltage.some one did some work on this amp before i got it.I want to find out on what settings should i put my scope on to take some test on the
output pads to make sure everything is ok .Also what wave form should i see on them.
(Learning to used scope tektronix 2215A

pic1 is the first leg on my PS FETs (5v div 10vus
pic 2 center leg (5v div 10us
Do they look ok for this amp?

Attached Images

	gate.JPG (286.6 KB)
	center.JPG (310.0 KB)
	scop1.JPG (305.9 KB)
	scop3.JPG (306.4 KB)
	socp2.JPG (330.3 KB)