Dear friends,
This is my first post on this forum and I hope somebody will help me.
I just have finished Aleph P 1.7 and I will use it with my DIY Aleph 5.
But something strange is happening.
I have two complete separate boards, one for left and one for right channel.
On both boards I have ''hot'' and ''cold'' signal, just like on original schematic. If I understand correctly this should work like four separate channels,two on each board, but if I try to connect stereo version on just one board ( for example I put signal on hot ''in'' and nothing on cold ''in'') I can hear music playing on both outputs hot and cold, like two channels are mixing in one. So Input is acting like I have mono version but if I touch fets with my hand I can hear left and right separation.
Is this normal not to have two completely separate channels on one board?
Thank you very much for replays.
This is my first post on this forum and I hope somebody will help me.
I just have finished Aleph P 1.7 and I will use it with my DIY Aleph 5.
But something strange is happening.
I have two complete separate boards, one for left and one for right channel.
On both boards I have ''hot'' and ''cold'' signal, just like on original schematic. If I understand correctly this should work like four separate channels,two on each board, but if I try to connect stereo version on just one board ( for example I put signal on hot ''in'' and nothing on cold ''in'') I can hear music playing on both outputs hot and cold, like two channels are mixing in one. So Input is acting like I have mono version but if I touch fets with my hand I can hear left and right separation.
Is this normal not to have two completely separate channels on one board?
Thank you very much for replays.