FS: Get-Set-Go Single Ended Triode Amplifier

I'm selling this amplifier for a close friend. I took the photos of the amp. Here are the details....

Stereo Tube Amplifier Get*Set*Go Single-End Triode

This is a single-ended triode amp built using diytube's Get*Set*Go board and a bill of materials, with a number of custom touches.

Information on this board and design can be found on the diytube website.

This amp produces @ 3 watts per channel. This is enough power to drive a pair of moderately efficient speakers to strong volumes, with that warm tube sound.

I purchased this amp from the builder, Turner Billingsley, in March, 2013. It was built in consultation with Tom McNally. The materials used were:

Hammond walnut chassis
Front Panel Express custom top panel
Edcor TRansformers (power & output) Made in USA
NOS Sylvania 6B4G power tubes (used only @ 3 hours)
Russian 6S4S power tubes (equivalent to 6B4G)
TungSol 6SU7 preamp tube
Russian NOS preamp tube 6H9C (equivalent to 6SL7)
GE 6AX5GT rectifier
Alps Blue Velvet volume pot
Gold RCA's
5-way binding posts
IEC power connector
No power cord is included, but any standard computer power cable will work (IEC plug on amp). The amp uses 5x20mm 2 to 3.5 slow-blo fuses (fuse is included)

Asking $499.99 (includes ground shipping in continental USA)